![]() ![]() Why does my pro tools always freeze when I try to use my Axe as a soundcard? What am I doing wrong? Is it possible to re-amp while using the Focusrite 2i4 as soundcard, with the same quality? I am switching to the Axe to re-amp because I don't know if there are ways to do it using the 2i4 interface. ![]() Then to re-amp I try to switch to Axe Fx as soundcard but Pro Tools just freezes every time. Wet: Axe Fx Output 1 L -> Input 1 2i4 interface -> 2i4 Outs (monitors)ĭry: Using "OUT 2 Echo Input 1" setting, I go Axe Fx Output 2 L -> Input 2 2i4 interface -> 2i4 Outs (monitors) Right now I'm doing this to record wet + dry tracks together, so I can re-amp later: This also means I'm getting into re-amping, but this is where I'm running into problems, because I'm currently using the 2i4 to record wet + dry/DI, then trying to switch to the Axe Fx as soundcard. ![]() I have both the 2i4 and Axe disabled in windows playback devices to avoid any driver conflicts w/ windows & protools.īoth 2i4 and Axe Fx being used 48k Pro Tools session.īasically, I'm just getting into recording a DI/dry track along with my distortion track, so I can start recording guitars for my band, and re-amp later. I also have a Focusrite 2i4 USB 2.0 interface & drivers connected, but problem seems to happen even if I have it "disabled" in device manager. I'm running Windows 7 Ultimate 64bit, Pro Tools 12.4. Hey guys, every time I switch to use my Axe Fx II XL as my playback engine (soundcard) in Pro Tools 12, it seems to freeze pro tools (not responding then I have to crash it).
0 Comments
Leave a Reply. |